| SYSTEM
OVERVIEW |
|
System
overview:
|
Line-interactive
2U rack / tower UPS offers protection from
blackouts, brownouts, overvoltages, surges
and line noise. Maintains sine wave AC output
during blackouts and continuously corrects
brownouts and overvoltages from 83 to 147
volts. Supports enhanced monitoring of UPS
and line power conditions via built-in USB
and DB9 serial ports, included PowerAlert
monitoring software and complete cabling.
Includes slot for SNMPWEBCARD accessory. Built-in
pair of load management banks offer remote
reboot of selected loads or load shedding
to enhance battery runtime for critical loads.
Supports rackmount and upright tower form
factors with included mounting hardware.
|
|
Voltage
compatibility:
|
120V
AC
|
|
Frequency
compatibility:
|
60
Hz
|
| OUTPUT |
|
Output
volt amp capacity (VA):
|
1500
|
|
Output
watt capacity (watts):
|
1000
|
|
Output
nominal voltage:
|
120V
AC
|
|
Output
voltage regulation:
|
LINE
MODE: Sine wave line voltage 120V (-21% +8%),
BATTERY MODE: Sine wave output within 5% of
120VAC
|
|
Output
frequency regulation:
|
LINE
MODE: Passes line frequency of 60Hz +/-10%
BATTERY MODE: Inverter output regulated to
60Hz +/-0.5Hz
|
|
Outlet
quantity / type:
|
8
NEMA 5-15R
|
|
Customized
load management receptacles:
|
Includes
2 load banks, each with 2 outlets that support
load shedding and remote reboot on demand
of locked network devices. Controllable via
PowerAlert software to switch off optional
loads, like monitors, to increase available
runtime for servers and other critical devices.
|
|
Overload
protection:
|
15A
input breaker
|
| INPUT |
|
Maximum
input amps:
|
10.4A
/ 1110 watts
|
|
Input
connection type:
|
NEMA
5-15P
|
|
Input
cord length:
|
10
ft., 14 gauge
|
|
Recommended
electrical service:
|
15A
120V
|
| BATTERY |
|
Full
load runtime:
|
10
minutes (1000 watts)
|
|
Half
load runtime:
|
25
minutes (500 watts)
|
|
DC
system voltage:
|
36
VDC
|
|
Typical
battery lifespan:
|
3-6
years, depending on usage
|
|
Battery
recharge rate:
|
2-4
hours to 90%
|
|
Replacement
Battery Cartridge:
|
RBC93-2U
|
| VOLTAGE
REGULATION |
|
Voltage
regulation description:
|
Line-interactive
voltage regulation system corrects input voltages
between 83 and 147 back to usable 120V nominal
levels.
|
|
Overvoltage
correction:
|
Input
voltages between 128 and 147 are reduced by
12%
|
|
Brownout
correction:
|
Input
voltages between 83 and 107 are boosted by
14%
|
| LEDS
ALARMS & SWITCHES |
|
Front
panel LEDs:
|
5
front panel LEDs - Green POWER LED, 3 color
BATTERY CHARGE LED, 3 color OUTPUT LOAD LEVEL
LED, red BATTERY WARNING LED.
|
|
Alarms:
|
3
function audible alarm indicates power failure
conditions (4 short beeps every 10 seconds),
overload (continuous short beeps) and low
battery (continuous tone)
|
|
Switches:
|
Includes
2 front panel mounted push-button switches
for system enable, self-test and alarm cancel
functions
|
| SURGE
/ NOISE SUPPRESSION |
|
AC
surge suppression:
|
480
joules
|
|
AC
suppression response time:
|
Instantaneous
|
|
EMI
/ RFI AC noise suppression:
|
Yes
|
| PHYSICAL |
|
Shipping
weight (lbs):
|
53
|
|
Shipping
weight (kg):
|
24.1
|
|
Unit
weight (lbs):
|
46
|
|
Unit
weight (kg):
|
20.9
|
|
Unit
Dimensions (HWD/in):
|
3.5
x 17.5 x 13.5
|
|
Unit
Dimensions (HWD/cm):
|
8.9
x 44.5 x 34.3
|
|
Shipping
Dimensions (HWD/in):
|
9
x 24 x 20.25
|
|
Shipping
Dimensions (HWD/cm):
|
22.9
x 61 x 51.4
|
|
Material
of construction:
|
Steel
|
|
Form
factors supported:
|
Rack/Tower
(2U)
|
|
Cooling
method:
|
Built-in
cooling fan
|
|
Battery
Access:
|
Battery
access door allows hot swap battery replacement
without powering connected equipment off
|
| ENVIRONMENTAL |
|
Operating
Temperature:
|
+32 to +104 degrees Fahrenheit / 0 to +40
degrees Celsius
|
|
Storage
Temperature:
|
+5 to +122 degrees Fahrenheit / -15 to +50
degrees Celsius
|
|
Relative
Humidity:
|
0
to 95%, non-condensing
|
|
Line
mode BTU/hr. (Max.):
|
87.2
|
|
Battery
mode BTU/hr. (Max.):
|
295.7
|
| COMMUNICATIONS |
|
Network
monitoring port:
|
Includes
2 built-in monitoring ports, 1-USB & 1-DB9.
Each supports on battery, low battery, power
restored, AC line voltage, DC battery voltage,
load percentage, battery charge current, battery
capacity, internal UPS temperature and line
frequency status messaging. Interface supports
timed inverter shutoff after unattended shutdown,
activate self-test and 10 second reboot of
connected equipment. Supports reboot of all
connected devices at once or individual load
banks via software interface. Compatible with
Tripp Lite's PowerAlert and WatchDog software.
|
|
Software
and cabling included:
|
Includes
PowerAlert UPS monitoring software for network
and standalone operating systems. Ships with
complete USB and DB9 cabling.
|
|
SNMP
compatibility:
|
Built-in
accessory slot accommodates internal SNMP
/ Web card and other network accessories
|
|
WatchDog
compatibility:
|
Compatible
with Tripp Lite's Watchdog Software to restore
operation to locked equipment through soft
reboot of application / OS or hard power off/on
reboot of connected equipment-ideal for unattended
kiosk applications
|
| LINE
/ BATTERY TRANSFER |
|
Transfer
time from line power to battery mode:
|
2-4
milliseconds
|
|
Low
voltage transfer to battery power:
|
83V
(resets to line power as line voltage increases
to 87V or higher)
|
|
High
voltage transfer to battery power:
|
147V
(resets to line power as line voltage decreases
to 143V or lower)
|
| CERTIFICATIONS |
|
Certifications:
|
UL1778
(USA), cUL (Canada), Class A (emissions),
NOM (Mexico)
|
| WARRANTY |
|
Optional
coverage:
|
3
year, 5 year, next day and on-site warranty
coverage available for select opportunities
|
|
Product
warranty:
|
2
year product warranty
|
|
Connected
equipment insurance (USA and Canada Only):
|
$250,000
connected equipment insurance (USA / Canada
only)
|
| SPECIAL
FEATURES |
|
EPO
port:
|
Includes
RJ11 EPO (emergency power off) port and cable
|
|
TVSS
grounding:
|
Includes
back panel grounding point with thumbscrew
for data line surge suppressors and other
network accessories requiring a safe grounding
point
|
|
Cold
Start:
|
Yes,
inverter can be "cold started" to enable temporary
AC output during a power failure
|
|
Appearance:
|
Attractive
all-black color scheme
|
