Introduction

FSP550PLG-SLI (SLI Ready) 550 Watts EPS12V and ATX12V Switching Power Supply

Features

• Complied with EPS12V and ATX12V standard
  
• Active Power Factor Correction Meeting with EN61000-3-2
  
• High efficiency and reliability
  
• Remote On/Off function
  
• Internal 12V DC fan included
  
• Noise Killer (Thermal fan speed control function)
  
• Low noise and ripple
  
• Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
  
• Output over voltage, short circuit, and over current protection
  
• 100% Hi-pot, ATE, and burn-in tested
  
• Re-settable power shut down
  
• Approved by UL60950, CSA C22.2 NO.60950, TUV EN60950, NEMKO EN60950 (CB Report), CE
  

Specifications

• Temperature Range: Operating 0° C ~ +25° C on full load; storage & shipping -20° C ~ +80° C
  
• Humidity: 95% on operating and 95% on storage
  
• Dielectric Withstand: Input to frame ground 1800V AC for 1 second
  
• Efficiency: 63% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
  
• Rise Time: Less than 20ms
  
• Hold-up Time: 17ms minimum at nominal input voltage
  
• Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
  
• Leakage Current: Not exceed 3.5mA at 264VAC/ 60Hz
  
• MTBF:100,000 hours on maximum load at +25° C degree
  
• Dimension (WxHxL): 150x86x140mm/5.9”x3.4”x5.5” inches

Input Characteristics

• Input Range: 90~265V AC, Full Range Input
  
• Frequency: 47~63Hz
  
• Input Current: 10A (RMS) @115V AC, 5A (RMS) @230V AC
  
• Inrush Current: 80A Max for 115V AC, 120A Max for 230V AC Cold start

Output Characteristics

• +5V and +3.3V total output not exceed 150W
  
• +3.3V, +5V, and +12V total output cannot exceed 528W

Photos