Introduction

FSP650-80GLC (SLI Ready & RoHS Compliant) 650 Watts EPS12V & ATX12V Switching Power Supply

Features

• SLI Ready & RoHS Compliant
• Complied with EPS12V and ATX12V standard
  
• Active Power Factor Correction (PFC) meet EN61000-3-2
  
• High efficiency and reliability
  
• Compatible with European Union directive 2002/95/EC (Restriction on Hazardous Substances).
  
• Remote On/Off function
  
• Internal 12V DC fan included
  
• Noise Killer (Thermal fan speed control function)
  
• Low noise and ripple
  
• Output over voltage, short circuit, and over current protection
  
• 100% Hi-pot, ATE, and burn-in tested
  
• Re-settable power shut down
  
• Complies with FCC part 15 subpart J class B and CISPR 22 Class B Approved • by UL 60950, CSA C22.2, TUV or VDE, NEMKO (CB Report), IEC 60950, EN and CE
  

Specifications

• Temperature Range: Operating 0°C ~ +40°C on full load; derate 5W/°C from 40°C to 50°C
  Storage & shipping -20°C ~ +80°C
  
• Humidity: 5~95% on operating and storage
  
• Dielectric Withstand: Primary to frame ground 1800V AC for 1 second
  
• Efficiency: 80% min on 230AC/50Hz & 78% min on 115VAC/60Hz at full load
  
• Rise Time: Less than 20ms
  
• Hold-up Time: 17ms minimum at nominal input voltage
  
• Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
  
• Leakage Current: Less than 3.5mA at 115VAC/60Hz
  
• MTBF: 100,000 hours on maximum load at +25°C
  
• Dimension (WxHxL): 150x86x140mm/5.9”x3.4”x5.5” inches

Input Characteristics

• Input Range: 90~264VAC, Full Range Input
  
• Frequency: 47~63Hz
  
• Input Current: 7.5A (RMS) @ 115VAC, 3.6A (RMS) @ 230VAC
  
• Inrush Current: No damage, typical 100A Max at cold start

Output Characteristics

• +3.3V and +5V total output not exceed 155W
  
• Total output for this subject power supply is 650W

Photos