Features

• For Dual Athlon systems only
• High efficiency
  
• Active PFC circuit meet EN61000-3-2
  
• Internal 12 VDC fan (ball bearing)
  
• Low noise and ripple
  
• Complies with FCC part 15 subpart J class B 115V AC operation and CISPR 22 class B at 230V AC operation
  
• Output over voltage protection
  
• Short circuit protection on all outputs
  
• MTBF above 100,000 hrs. at 25° C
  
• 100% Hi-pot & ATE tested
  
• Short circuit protection on all outputs
  
• Resettable power shut down
  
• 100% burn-in under high ambient temp.
  
• Approved by UL 1950, CSA C22.2 No. 234 Level 3, IEC 950, VDE 60950, NEMKO EN 60950(CB Report), CE
  

Specifications

• Maximum power: 460W
• Temperature Range: Operating 0° C ~+25° C on full load; storage & shipping -20° C ~ 80° C
  
• Temperature Coefficient: 0.01% / ° C
  
• Transient Response: Output voltage returns in less than 1 ms max. at a 25% load change
  
• Hold-up Time: 18 ms minimum at full load and nominal input voltage
  
• Dielectric Withstand: Input to frame ground 1800 VAC for 1 second
  
• Humidity: 95% RH
  
• Efficiency: 68% at minimum measured at 110V AC main voltage and frequency with maximum load on all output
  
• Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1 ms minimum
  
• Overload Protection: 150% Max.
  
• Over Voltage Protection: +3.3V output: 4.5V; +5V output: 6.5V; +12V output: 14.5V
• Input Characteristics
  
  • Input Range: 90~265 VAC, full range
    
  • Frequency: 47-63 Hz
    
  • Input Current: 9A (RMS) @115VAC, 5A (RMS) @230VAC
    
  • Inrush Current: 80A Max. for 115 VAC, 120A Max for 230VAC
• Remote ON/OFF Control
  
  • The power supply shall accept a logic open collector level which will disable/enable all the output voltages (exclude +5V standby).
    
  • As logic level is low/high, output voltages are to be enabled/disabled.
• Dimensions (WxHxL): 150x86x140(mm)/5.9”x3.4”x5.5”